GE AEM14 Serie Manual Del Propietário página 11

PREPARE THE WINDOW AND INSTALL
5
THE CASE
A
Cut the window sash seal to the proper length.
Peel off the backing and attach the seal to the
underside of the window sash.
Open the window and mark the center of the
B
window sill.
Carefully slide the case into the window and
C
center the case. Lower the window behind
the top mounting rail. Pull the bottom of the
case forward so that the bottom mounting rail
is tight against the back of the window stool.
Mount the case to the window sill using 2 type
B screws. Drill pilot holes, if necessary.
Stool
Assemble the V-support and V-support bracket
D
with Type F nut and bolt
Left
Sill angle
bracket
V-support Type
F bolt and nut
Installation Instructions
2 type B screws
Type E bolt
and nut
Right
PREPARE THE WINDOW AND INSTALL
5
THE CASE (continues)
Position the V-supports
E
on the case bottom so
that they will be near the
outside wall. Attach a
V-support to each side of
the bottom of the case
with Type E bolts, 2 for
each support.
Adjust sill angle brackets to rest on sill.
F
Extend the left and right accordion panels
G
to the vertical window sashes. Drill pilot holes
and attach the top corners with 2 type C
screws.
Type C
screw
11
V-support
Sill
Bracket
Type C
screw