Entering The Code Number After A Voltage Interruption; Switching On/Off; Switching On/Off With The On/Off Button; Switching On/Off Via Vehicle Ignition - Bosch Calais USB40/80 Instrucciones De Manejo

38 | en
f Press the MENU 7 button, repeatedly if
necessary.
Entering the code number after a
voltage interruption
f Switch on the device.
The display first shows "CODE" and then
"0000". You can enter the code:
Note:
If you enter an incorrect code
number, "ERROR" appears on the
display, after which "0000" is shown
again. You can make the entry two
more times. After the third incorrect
entry, the device is locked for 1 hour.
During this time, the display shows
"BLOCKED". If you switch off the
device during this waiting period, you
will have to wait again for a full hour
after switching it on again.
f Enter the code number as described in the
section "Switching code query on/off".
f When the correct code number is shown
on the display, hold down the station
button 5 < for longer than 2 seconds.
The device will be switched on. "TIMESET" will
appear for about 2 seconds on the display,
after which the menu for entering the time will
open.
f Enter the time as described in the "Setting
the time" section of the "Time" chapter.
f Confirm the time you have entered by
pressing the SRC > key.
Once the time has been confirmed, the device
switches into normal operating mode.
CODE theft protection | Switching on and off

Switching on/off

There are various ways of switching the device
on/off:
Switching on/off with the On/Off
button
f Press the On/Off button 3 to switch on.
f To switch the device off, press and hold
down the On/Off button 3 for longer
than two seconds.
Note:
To protect the vehicle battery, the
device is automatically switched off
after an adjustable time period if the
vehicle ignition is switched off (see
the section "Adjusting the switch-off
time" in this chapter).
Switching on/off via vehicle igni-
tion
If the device is connected to the vehicle's
ignition and you did not switch the device off
by pressing the On/Off button 3 , it is
switched on or off with the vehicle ignition.

Setting the switch-off time (HOUR)

f Press the MENU 7 button to open the
menu.
f Press the MENU 7 button repeatedly
until "HOUR" appears on the display along
with the current setting.
f Turn the volume controller 1 to the left
or right in order to set the switch-off time
to between 1 and 60 minutes.
Robert Bosch Car Multimedia GmbH