Orbegozo CP 92105 Manual De Instrucciones página 11

CP 92105 CP 93105
FAN INSTALATION
1. Mount the mounting bracket onto outlet box by the screws and washers.
2. Hang the ball joint and the fan onto the bracket. Make sure the guide pin of bracket is fitted into slot of
ball joint.
3. Insert the remote control receiver between the bracket and the downrod, and the sensor as shown.
4. Connect the pair of 3 way male/female connector from the bracket to the remote control receiver and
connect the pair of 4 way male /female connector from the remote control receiver to the fan.
5. Connect wires from supply and the bracket to the wiring terminals.
6. Attach canopy to the bracket and fix it by tightening the screws
7. Install fan blade sets onto blade bracket by tightening the screws and washers.
8. Insert the male connector into the female connector securely to install the lamp stud.
9. Fit the light kit to the switch housing. Ensure you don't trap any wires.
10. Install a bulb (E27, Max 60W x2) to the lamp holder.
11. Install the lamp shade onto the lamp stud by rotating the lamp shade clockwise.
11