Orbegozo CP 92105 Manual De Instrucciones página 12

CP 92105 CP 93105
OPERATING THE FAN
- Select the fan speed by pressing the speed control button on the remote control transmitter :
HI: High Speed
- The switch on motor housing for controlling the fan blades rotating direction controls the direction of
air movement.
- Caution : Before using this rotating direction switch, turn OFF the fan and ensure the fan stops
rotating to prevent injury to yourself and damage to the moto.
- Cold weather: Push the switch 'UP' so that the blades will bring the warm air trapped near the ceiling
fan to move downwards throughout the room.
- Hot weather: Push switch 'DOWN' so that the blades will create a breeze and circulate the air to the
room.
- Pressing the 'ON/OFF' light button on the remote control transmitter can control the turning on or off
of the light.
- Pressing and holding the 'DIMMER' button on the remote control transmitter can adjust the level of
light brightness.
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and to switch the light and fan on
or off.
- Replace the batteries by sliding the battery compartment cover on the remote control transmitter in
the direction of the arrow, fit 2 x 'AAA' batteries, and ensure the polarity of the batteries match with
the figures shown in the battery compartment. (Note : Batteries NOT included).Re-assemble the
battery compartment cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
- Don't attempt to recharge expired bateries. There are special rechargeable batteries,which are clearly
marked with.
- Don't dispose of batteries in fire to avoid explosion.
TRANSMITTER OPERATION:
Point the remote at the infrared sensor to power the fan.
LIGHT ON: Make a short press to switch on the light.
LIGHT OFF: Make a short press to switch off the light
HI: Select high speed fan.
MED: Select medium speed fan.
LOW: Select low speed fan.
VENTILADOR OFF: Turn off the fan rotation.
MED : Medium Speed LOW : Low Speed OFF : Off
12