MAGLOGIX MX-220-L Manual De Instrucciones página 11

Maintenance and Inspection of the Lifting Magnet
Regular maintenance and inspections are necessary to ensure the safe use and operation of the Lifting Magnet.
Furthermore, country-specific standards and regulations must be observed depending upon user application (e.g.
ASME B30.20B, DGUV-Information 209-013; AMVO).
The below maintenance intervals are classified according to the recommended schedule.
Before every use...

visually inspect the Lifting Magnet for damage

clean the magnetic contact area of any contamination (i.e. rust, metal chips) that would cause unevenness
of attachment or an air gap between the workpiece
Weekly...

make sure the activation lever is not bent or the plastic of the activation lever is not cracked

make sure the activation lever springs into the locking notch when in the ON position

inspect the magnetic contact area for any protruding scratches, pressure point deformations, and/or cracks
into the magnetic contact area. Have the Lifting Magnet repaired by the manufacturer if any unevenness of
the magnetic contact areas is identified.

inspect the load swivel for damage, deformation, cracks or wear and have it replaced if necessary
Monthly...

check the markings and labeling on the Lifting Magnet for legibility, damage, modification, or removal. To
meet full compliance, the entire Lifting Magnet must be returned to the manufacture for calibration and
relabeling.
Annually...

have the load-bearing capacity of the magnet checked by the supplier or an authorized workshop, should
the application so require.
An annual inspection is recommended for the triple safety system of this lifting magnet. We will be glad to assume
this inspection for you first-hand. Please send us an email to:
You will then promptly receive an offer and have the assurance that the Lifting Magnet will be inspected in a
process-reliable manner where it was actually produced.
Unauthorized repairs or modification to the Lifting Magnet are not permitted.
If you have any questions, please contact the manufacturer.
MX-Test@maglogix.com
11