Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe AXOR Modo De Empleo/Instrucciones De Montaje



Safety Notes

Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal

pressures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
• Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 0,15 MPa.
• This mixer is equipped with a flush stream, which
enhances the natural side of the life element water.
As this flush stream does not contain any air, we
recommend the use of very deep basins to prevent
water spray.
• This mixer series is produced with the following spray
pattern - with the spray former with a waterfall. For an
alternative spray, an aerator with a round monospray,
that can changed easily on the spot, is enclosed (see
page 33).

Technical Data

This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
4
English

Symbol description

®
(flow
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31
Do not use silicone containing acetic acid!
Dimensions (see page 34)

Flow diagram

(see page 34)

with EcoSmart
®

without EcoSmart
®
Spare parts (see page 36)
Special accessories
special tool (58085000) order as an extra
Installation kit order as an extra
Operation (see page 38)
Cleaning (see page 37) and
enclosed brochure
Test certificate (see page 38)