Assemblage / Armado; Operation - Echo EGi-2300 Manual Del Operador

OPERATION

Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE
This product is equipped with a spark arrestor that has
been evaluated by the USDA Forest Service; however,
product users must comply with Federal, State, and
local fire prevention regulations. Check with appropriate
authorities. Contact customer service or an authorized
dealer to purchase a replacement spark arrestor.
NOTICE
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized dealer for assistance.
Applications
This generator is designed to supply electrical power for
operating compatible electrical lighting, appliances, tools,
and motor loads.
Before Operating the Unit
 Only use OUTSIDE and at least 20 feet away from windows,
doors, and vents as recommended by the U.S Depart-
ment of Health and Human Services Centers for Disease
Control and Prevention. Your specific home and/ or wind
conditions may require additional distance.
 NEVER use inside a home or garage, EVEN IF doors and
windows are open.
 Always position the generator on a flat firm surface.
Special Requirements:
There may be General or State Occupational Safety and
Health Administration (OSHA) regulations, local codes or
ordinances that apply to the intended use of the generator.
Please consult a qualified electrician, electrical inspector, or
the local agency having jurisdiction:
 In some areas, generators are required to be registered
with local utility companies.
 If the generator is used at a construction site, there may
be additional regulations which must be observed.
WARNING
WARNING
USB Charging Ports
See Figure 1.
The USB-dedicated charging ports will charge most USB-
compatible devices.
 For MP3, cell phones, and other small USB devices (up
to 1.9 Amps), connect to the top USB port.
 For tablets and high-charging current devices (up to 2.1
Amps) connect to the bottom USB port.
NOTE: The USB-dedicated charging port provides power
only; it does not provide any communication capabilities. A
suitable USB cable must be provided by the user.
ECHO COMMAND
See Figure 2.
NOTE: The LCD display will not work unless the unit is running.
Fuel level: The fuel level indicator will show how much fuel
is remaining.
Load level: The load level indicator will show the connected
load. If the generator is approaching the maximum wattage/
amperage capacity, the indicator will blink. If load level capacity
is exceeded, the LCD display will show OVERLOAD. To reset
the generator, remove all loads from the generator and press the
reset button (see fig. 1). Add loads back to the generator one at
a time being careful not to exceed the generators wattage rating.
Run time: The LCD display will show the approximate
remaining run time based on fuel level and load.
Auto idle: The LCD display will show if the idle is on or off.
Bluetooth : Once paired, the LCD display will indicate
®
whether or not the ECHO COMMAND
through Bluetooth
® .
Checking/Adding Lubricant
See Figure 3.
Attempting to start the engine before it has been properly
filled with lubricant will result in equipment failure.
NOTE: If a separate engine manual is provided for this
product, please follow the instructions provided in the
engine manual instead of the information listed below.
Engine lubricant has a major influence on engine performance
and service life. For general, all-temperature use, SAE 10W-
30 is recommended. Always use a 4-stroke motor lubricant
that meets or exceeds the requirements for API service
classification SJ.
This engine comes with a feature that will shut off the engine
when a specific lubricant level is not maintained. The engine
will not restart until an appropriate lubricant level is reached.
NOTE: Non-detergent or 2-stroke engine lubricants will
damage the engine and should not be used.
 Loosen the knob at the side of the engine cover. Remove
cover and set aside.
 Unscrew the oil cap/dipstick and remove.
 Wipe dipstick clean and re-seat in hole; do not re-thread.
English
LCD Display
™
app is connected
™
NOTICE
13