Cedar Ridge CRHSD25RT Manual De Instalación Y Funcionamiento Del Propietario página 11

This appliance is factory
preset for propane/LP gas.
No changes are required for
connecting to propane/LP . Only
a qualified installer or service
technician can perform gas selec-
tion and connecting to gas supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited. The access plate
to the simple switching means
shall not be opened while the
heater is in operation.
CAUTION: To avoid gas
leakage at the inlet of regulator,
a qualified installer or service
technician must use supplied
hex plug with sealant.
WARNING: Do not attempt to
access or change the setting of
the fuel selection means.
Access to and adjustment of the fuel selection
means must only be performed by a qualified
service person when connecting this appliance to
a specified fuel supply at the time of installation.
Change of the selector setting to other than
the fuel type specified at the time of installa-
tion could damage this appliance and render
it inoperable.
The installer shall replace the access cover
before completing the installation and operat-
ing this appliance.
For changing from propane to
natural gas supply:
1. Remove 1 screw from gas selector cover
plate (see Figure 5). Rotate to expose fuel
selector device.
2. For NATURAL GAS, press in knob using a
flat screwdriver with a blade with thickness
of a quarter and turn knob clockwise
until the knob locks into the NG position
(see Figure 5). Fuel selection device must
be locked in the NG position. Do not oper-
ate heater between locked positions!
200018-01A
INSTALLATION
GAS SELECTION
3. Replace cover over fuel selection device
and reinstall screws.
4. Remove hex plug (with wrench provided)
from natural gas inlet of regulator (see
Figure 5). Install hex plug into LP inlet of
regulator. Install gas line into NG inlet of
regulator. Use thread sealant to assure
there are no leaks.
NG
Fuel
Selector
Knob
Figure 5 - Settings for Natural Gas
For changing from natural gas
1. Remove 1 screw from gas selector cover
plate (see Figure 6). Rotate to expose fuel
selector device
2. For PROPANE GAS, press in knob using a
flat screwdriver with a blade the thickness
of a quarter and turn knob counterclock-
wise
LP position (see Figure 6). Fuel selection
device must be locked in the LP position.
Do not operate heater between locked
positions.
3. Replace cover over fuel selection device
and reinstall screws.
4. Remove hex plug (with wrench provided)
from propane/LP gas inlet of regulator
(see Figure 6). Install hex plug into NG
inlet of regulator. Install gas line into LP
inlet of regulator. Use thread sealant to
assure there are no leaks.
NG
Fuel
Selector
Knob
Figure 6 - Settings for Propane/LP Gas
www.usaprocom.com
Back of Stove
LP
Gas Select
Selector de gas
Hex Plug
Selection
supply to propane supply:
until the knob locks into the
Back of Stove
LP
Gas Select
Selector de gas
Gas Connection
Fitting
Selection
Gas Inlet
LP NG
Gas esté
INLET GAS PRESSURE
MAX 1/2 PSIG (3.5KPa)
Gas Connection
Fitting
Gas Inlet
LP NG
Gas esté
INLET GAS PRESSURE
MAX 1/2 PSIG (3.5KPa)
Hex Plug
11