Cedar Ridge CRHSD25RT Manual De Instalación Y Funcionamiento Del Propietario página 19

When matching security codes, be sure slide switch on the receiver is in the REMOTE posi-
tion. To program the remote receiver to LEARN a new security code, press and release the
LEARN button on the top of the remote receiver, and then press ON or OFF button on the
transmitter. A change in the beeping pattern at the receiver, indicates the transmitter's code
has been programmed into the receiver.
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the
type and quantity stated in table to the right.
• Do not mix old and new batteries. New bat-
teries should be the same brand for best
results.
This appliance must not be used with glass
doors in the closed position. This can lead to
pilot outages and severe sooting outside the
fireplace.
The remote operates on 2 AAA batteries.
Key Settings
ON - Operates unit to on position, manually
operated solenoid ON.
OFF - Operates unit to off position, manually
operated solenoid OFF.
MODE - Changes unit from manual mode to
thermo mode.
SET - Sets temperature
in thermo mode.
Figure 20 - Remote Control
200018-01A
OPERATION
Matching Security Codes
Battery Instructions
REMOTE CONTROL OPERATION
TEMP
www.usaprocom.com
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installation
may void the warranty on the product.
• For remote control systems, maximize bat-
tery life by turning off the receiver when it
is not in use.
• For long periods of non-operation, remove
batteries from all components for safety.
Component
Ignitor
Remote Control
Remote Receiver
*Note: Quantity depends on model of remote
Control.
LCD Liquid Crystal Display
1. DISPLAY Indicates CURRENT room
temperature.
2. °F or °C Indicates degrees Fahrenheit or
Celsius.
3. FLAME Indicates burner/valve in operation.
4. ROOM Indicates remote is in THERMO
operation.
5. TEMP Appears during manual operation.
6. SET Appears during time the of setting
the desired temperature in the thermo
operation.
1
4
ROOM SET TEMP
Figure 21 - Remote Control Display
Type of Battery Qty.
AAA
AAA 2 or 3*
AA
6
1
4
2
3
5
19