Cedar Ridge CRHSD25RT Manual De Instalación Y Funcionamiento Del Propietario página 18

12. Press the LEARN BUTTON on the front of
the remote receiver box until you hear a
beep (see Programming the Remote and
Receiver).
13. Press the ON button on the remote control
transmitter to light the burner. (This will
also "learn", or program, the transmitter
and the receiver).
Note: If the transmitter is lost or damaged,
the slide switch on the receiver can be
used to operate the heater.
Shutting Off Heater
Turn control knob clockwise
OFF position.
1. Follow steps 1 through 7 under Lighting
Instructions, page 17.
2. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
Install Batteries
Batteries are required in both the Remote
Control (Transmitter) (2 AAA size) and Re-
ceiver (4 AA size) (see Figure 18).
Note: Be sure batteries are placed correctly.
Reversing the batteries can cause damage to
the receiver and remote. Replace all batteries
on a yearly basis or sooner.
Receiver
Figure 18 - Installing Batteries in Remote
Control and Receiver
18
OPERATION
TO TURN OFF GAS TO APPLIANCE
to the
MANUAL LIGHTING PROCEDURE
REMOTE CONTROL SYSTEM
Remote Control
(Transmitter)
www.usaprocom.com
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: If input gas type is
NG, make sure NG pilot burner ig-
nites. If input gas type is LP, make
sure LP pilot burner ignites.
Shutting Off Burner Only (pilot
stays lit )
Turn control knob clockwise
PILOT position.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
4. Make sure the heater screen is in place
before operating heater.
Programming the Remote and Receiver
The remote and receiver must be "learned"
to one another.
1. Turn control knob on the heater to the ON
position.
2. Place the slide switch on the receiver in
the remote position (see Figure 19).
3. Use a pen or small screwdriver to gently
press and release the recessed LEARN
button on the face of the receiver. You will
hear a beep.
4. Press the ON button on the remote (see
Figure 20, page 19). You will hear a series
of beeps. Your appliance should come on.
Learn Button
LEARN
ON
Figure 19 - Receiver
to the
Slide Switch
REMOTE OFF
200018-01A