Tabla de contenido
Publicidad
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - 31471xx1
handshower
tub filler
Flow rate - 31432xx1
handshower
tub filler
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Protection against backflow is provided by check
valve and an automatically resetting diverter.
• This trim is for use with rough #10452181 (not
included). The rough must be installed and the
finished floor surface completed and made
watertight.
• 31471xx1 only: This showerhead is for use
with an automatically compensating valve rated at
1.5 GPM (5.7 L/min) or less.
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.0 GPM (7.6 L/min)
5.3 GPM (20 L/min)
1.75 GPM (6.6 L/min)
5.3 GPM (20 L/min)
• 31432xx1 only: This showerhead is for use
with an automatically compensating valve rated at
1.3 GPM (4.9 L/min) or less.
• This unit is not anti-scald. If required by local code,
install in combination with an approved remote
pressure balance valve or other approved device.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve must be no
higher than 120°F. In Massachusetts, the maximum
output temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
Tabla de contenido
