Garland PRESS 491 FLAE Manual De Instrucciones página 22

English
to or less than 30mA. Electricity tension should
be 230v, frequency 50Hz and have a magnet and
thermic switch between 10A-16A.
Never use this machine if the cable or the plug are
damaged. Before connecting the machine check
that the cable and the plug are not damaged. If you
discover that either of these elements are damaged,
take your machine to your nearest after sales
dealer. Should the cable be damaged, unplug the
machine inmediately. Damaged or tangled cables
increase the risk of electric. When using a cable
extension, make sure that its minimum section is
1.5 mm 2 and no longer than 25 metres, always
unrolled and adequate for outdoor use. The use of
the cable extension adequate for outdoor use, reduces
the risk of electric shock.
Place the cable extension in such a way that it does not
touch the water and that it will not fall into the water
when the pump starts working. The cable extension
must always be well away from the water and dry.
All electric conexions must remain away from the
water and at a safe distance from the pump and any
water conducts and protected from humidities.
Do not expose this machine to rain and wet and
humid conditions. If water enters the machine there
will be a higher risk of electric shock.
Always disconnect the machine from the mains
before carrying out any maintenance work on
the pump. Only manipulate the machine when the
machine has been unplugged.
The electrical switch of this machine must coincide
with the mains switch. Do not modify the switch in
any way. If no parts have been modified and they fit
perfectly, there will be no electric shock accidents.
All manuals and user guides at all-guides.com
Do not overstretch the cable. Do not use the cable
to transport the machine, lift the machine and to
unplug the machine. Maintain the cable far away
from heat sources, oil, sharp edges or other moving
parts. Damaged or tangled cables increase the risk of
electric shock.
Never use this machine if the cable or the plug are
damaged. Before connecting the machine check
that the cable and the plug are not damaged. If you
discover that either of these elements are damaged,
take your machine to your nearest after sales
dealer. Should the cable be damaged, unplug the
machine inmediately. Damaged or tangled cables
increase the risk of electric shock.
The substitution of the plug or cable should only be
carried out by your service dealer.
2.5. USAGE AND CARE OF THIS MACHINE
This machine has been designed for pumping
clean water at a maximum temperature of 35C. Do
not use this pump to pump other liquids different to
clean waters such as sea water, dirty water, petrol,
oils, solvents, food liquids (milk, soft drinks, etc) or
residual waters. This machine is for private domestic
use in domestic water installations and domestic
watering systems.
This machine is for private use in domestic water
installations, watering systems or similar installations.
It has not been designed for continuous use.
Do not allow the machine to work with no water
as there is a clear risk of breakage. Be vigilant that
the suction tube is always inside the water when
pumping.
Use this machine and its accessories following the
instructions and use taking into account the job to
22/92