Garland PRESS 491 FLAE Manual De Instrucciones página 30

English
6.3.1. OFF MODE "POWER ON"
In this mode the pump is off but connected to
electrical current.
6.3.2. CONTINUOUS MODE "EVER - ON MODE"
Ever - On Mode
Not Recommended
In this mode the pump is in constant operation
regardless of whether or not the pump has water or
whether there is water flow.
IMPORTANT NOTE: In the "Ever - On Mode" operating
mode the pump works constantly regardless of
whether or not there is water inside the pump and
also regardless of whether the stopcocks are open
or closed. This mode is only to check that the pump
is working but should not be used for more than a
moment and with water to check that the pump is
working.
6.3.3. AUTOMATIC MODE "AUTOMATIC MODE"
Automatic Mode
In this mode the pump works in automatic mode.
When the pump detects water consumption it starts
to give pressure to the circuit and when it detects that
there is no water consumption it stops.
6.3.4. TIME MODE "TIME MODE"
In this mode the pump will run in Automatic Mode in
a time interval defined by the user and the rest of the
time it will be in Off Mode.
6.3.4.1 SCHEDULE MODE PROGRAMMING
If the Schedule Mode is not programmed the LCD
screen shows the following message:
A) Clock settings:
All manuals and user guides at all-guides.com
1. Press the MODE button until the display shows
"Time Mode".
2. Wait a moment until the message "Time Now"
appears.
Time Now
Save
3. Press the "SET" button to set the hour.
Time Now
Next
Pressing the "SET" button increases the hours
and pressing the "MODE" button decreases the
hours. Once the hour is set, press the "CHECK"
button to memorize and go to the next step.
Note: The clock works in 24h mode
4. Now adjust the minute of the hour in the same
way using the buttons "SET" to increase and
"MODE" to decrease the minutes. Once the
minutes have been set, press "CHECK" to
memorize the minutes and go to the next step.
5. Now set the pump start time. The message will
appear on the screen:
Time On
Save
Press the "SET" button to set the start time and
the display will change to:
Time On
Save
30/92
Time Mode
Not Set
00:00
Set Exit
00:00
+ -
00:00
Set Exit
00:00
+ -