Dmx Configuration - NEO PROTON 6 HEX USB Manual De Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Auto Show

The fixture has a built in automatic program. To access this,

please see the below instructions:

• Press the button MENU so many times until the

display shows P--, then press the button ENTER.

• Press the button UP/DOWN to switch between

programs P1-P4.

•Press the button MENU until S-- appears on the

display.

• Use the button UP/DOWN to select the auto

programs speed S001 - S100 (slow-fast).

• Press the button ENTER save the setting.

Sound mode

In music mode, via its integrated microphone, the unit can

be controlled by music with a clear rhythm in the bass range.

If the music control should not work optimally, increase the

volume or reduce the distance between the sound source

and the light effect unit.

• Press the button MENU so many times until the

display shows Snd.

• Using UP/DOWN button, select one of the

modes Snd1 or Snd2. Press ENTER

• You can set the microphone sensitivity pressing

the button MENU so many times until the display

show Sens

• Using the button UP/DOWN, select the desired

value sensitivity (slow-fast) u0 - u100.Press ENTER

Static Color

• The fixture has the ability to accept custom static

color settings. Access these chases via the control

panel on the back of the fixture.

• Press the button MENU so many times until the

display shows C.., then press ENTER.

Manual Color

This mode allows to combine the colors red, green, blue,

amber, white and UV (r, g, b, a, w, p).

• Press the button MENU so many times until the

display shows U-- , then press the button ENTER.

P. 10

PROTON 6 HEX USB

ENGLISH VERSION

• Select the color r, g, b, a, w, p through the buttons

UP/DOWN. Then ENTER.

• Using UP/DOWN button, select the desired

color value 000 - 255.

• Press ENTER button to continue to the next color.

• Continue until the desired mix is obtained.

• Press the MENU button to go back or to meet the

waiting time to exit the setup menu.

Dimmer

Enter in Dimmer mode to select specific dimming curve,

press the button MENU several times until shows dIM and

press ENTER to confirm.

• Press the button UP/DOWN to select OFF -

dIM1 - dIM2 - dIM3.

• Press ENTER button to store.

• Press the MENU button to go back or to meet the

waiting time to exit the setup menu.

Linking

Several Units may be interconnected in order to control all

further slave units to the same effect of the master unit. Use

standard DMX cables to daisy chain your units together via

the DMX connector on the rear of the units. For longer ca-

ble runs, we suggest a terminator at the last fixture.

• Connect the DMX OUT of the master unit via 3

pole XLR cable to the DMX IN of the first slave unit.

• Connect the DMX OUT of the first slave unit to

the DMX IN of the second slave unit, etc. until all

units are connected in a chain.