Dmx Addressing - NEO ION 575 Manual De Usuario

5. DMX CONNECTION AND DMX PROTOCOL

DMX addressing

The device is controlled by universal DMX 512 pro-
tocol, DMX address is the start channel used to re-
ceive instructions from the external controller. For
independent control, each fixture must be assigned
its unique address control channels. For example,
this device has four channel modes: 11/14, if we set
the mode at standard 11 channels mode, and there
are several models need to be independently con-
trolled, we just simply address first fixture at 1, and
second fixture at 12, third one at 33, etc.
If the devices have the same address, they will be-
have synchronically.
DMX addressing is limited, don't set the address so
high that without enough control channels for the
fixtures.
Display is flashing when no DMX signal is received.
Connection: use DMX cable with 3-pin XLR-plugs
to connect the controller with the fixture or one
fixture with another.
P. 12
Neo ION 575 -
English version
This device is equipped with 3-pins DMX in and
out sockets only. Pin 1 = GND, Pin 2 = Signal (-)
, Pin 3 = Signal (+)
The termination is prepared by soldering a 120Ω
resistor between pins 2 and 3.