Choosing An Appropriate Location; Mounting The Lamp - Perel Tools LEDA301-P Serie Manual Del Usuario

LEDA301xx-xP/302xx-xP/303xx-xP/305xx-xP
6.3

Choosing an appropriate location

You can adjust the detection area according to your needs: turn
the device to the left or right and aim it up or down. Note that the
detector is much more sensitive to objects moving across the
detection area than it is to objects coming straight at it. This is a
very important consideration when selecting the mounting
location.
The floodlight should be fixed to a stable outdoor wall made of a
non-flammable material approximately 1.8-2.0 m above the
ground, preferably in a location under eaves where the unit is
protected from the elements and shielded from direct sunlight.
Do not block the front of the detection window and make sure the
detection area holds no moving objects.
Do not install the device close to air conditioning vents,
radiators, etc.
6.4

Mounting the lamp

1. This luminaire does not have a built-in device to disconnect it
from the electric mains. Make sure to electrically isolate the
luminaire before installation or maintenance activities are
performed.
2. Use the mounting bracket [1] to determine the location of the
mounting holes.
3. Drill the holes and secure the bracket using screws and wall
plugs.
4. Connect the power cable to a suitable junction box (not incl.).
Make sure the connection is properly earthed. Make sure there is
no strain on the cable; leave sufficient slack.
V. 01 – 08/07/2013 6 ©Velleman nv