Troubleshooting - GMC GMC1152G Instrucciones Originales

Troubleshooting

Problem
Angle grinder does not start when On/Off Switch (4) is depressed
Cutting disc is off centre/vibrating eccentrically
Possible cause
No power
Machine defective
Grinding/cutting disc is overly worn
Deformed grinding/cutting disc
Grinding/cutting disc not fitted correctly
13
Solution
Check mains connection
Contact your GMC dealer or authorised service centre
Turn off the grinder, remove and replace the disc, as instructed in
'Fitting a grinding or cutting disc'
Turn off the grinder, remove and replace the disc, as instructed in
'Fitting a grinding or cutting disc'
Turn off the grinder and refit the disc as instructed in
'Fitting a grinding or cutting disc'
GB