Dymo LabelWriter 4XL Guía Rápida De Inicio página 9

4. Loading Labels
Important!
In order for the labels to feed properly during printing, pay attention to the following when loading
labels on the spool and into the printer:
• The label spool guide must be pushed flush against the label roll, with no gap. See Figure 6.
• The labels must be loaded with the left edge of the label inserted against the left edge of the
label feed slot. See Figure 8.
To load a label roll
Press the form-feed button to eject the labels that protected the printer
1
during shipment.
Open the top cover and remove any packing material inside the
2
label compartment.
Remove the label spool from inside the top cover and pull the spool
3
guide from the spindle.
Hold the spool spindle in your left hand and place the label roll on the spindle so that the labels
4
feed from underneath and the left edge of the label roll is firmly against the side of the spool.
See Figure 5.
Spool
Spool
spindle guide
Figure 5
5