Publicidad
Idiomas disponibles
Idiomas disponibles
Replace the batteries as soon as the symbol "Lo" appears in the display or the device cannot be switched
on at all!
General instructions for using batteries:
Danger:
Never expose batteries to extreme conditions, such as heat or strong sunlight! There is an acute risk of
explosion and leakage!
Danger:
Make sure that batteries can not be swallowed by children, animals and adults! In particular, keep children
and animals away from this product! If one or more batteries are swallowed, seek medical attention immediately!
Here is an acute danger to life. The substances contained in the battery can cause severe poisoning!
Caution:
Remove leaking batteries from the device immediately! The battery acid contained in the battery can
damage the unit! Avoid direct skin contact with leaking batteries! Wash your hands immediately after contact and
take care that the battery acid does not get into your skin, eyes or mucous membranes! Dispose of leaking and old
batteries according to the regulations.
Replace old batteries with batteries of the same type!
Do not use rechargeable batteries. They have a too low voltage!
Remove the batteries from the battery compartment when you are not using the remote control for more than
a month. Make sure that the battery compartment is always closed when the battery is inserted!
Only operate the device when the battery compartment is closed!
Non-rechargeable batteries are not to be re-charged!
New batteries should not be used together with used batteries!
Always use batteries with the same type!
Never short the terminals of the batteries!
Change unit (Fig.3):
1: Switch on or change the weight unit.
Initial start up:
A short warm-up phase is recommended for initial commissioning or when relocating.
Please follow the procedure as described:
1. Place the device on a firm, vibration-free and level surface. Note: Please make sure that all 4 leveling feet
of the balance touch the floor.
2. Place one foot on the scale to activate the device.
3. Remove your foot and wait for the scale to turn off. Leave the scale turned off for about 10 seconds.
4. The scale is now ready for operation.
Measure weight:
1. Place the device on a firm, vibration-free and level surface. Please make sure that all 4 leveling feet of the
balance touch the floor.
2. If possible, stand in the middle of the scale. Do not stand on the display! Attention: If you stand on the
edge of the scale, the scale may tilt to the side. There is a risk of injury!
3. The scale is now activated and measures your weight.
4. During the measurement, hold as still as possible to avoid measuring errors.
5. The measurement is finished as soon as the weight display starts flashing.
6. Automatic switch-off function: After approx. 8 seconds of inactivity, the device switches itself off
automatically.
7
Publicidad
