REV Ritter 00973 Manual Del Usuario página 5

How to install the halogen floodlight projector with movement detector
The halogen floodlight projector with movement detector has to be fixed tightly to the wall. Vibrations will
have the same effects like thermal movement within the detection range.
About the location for installation
1. The space which you want to be detected has to be reached by the beams of the movement detector
(see pictures regarding the detection range as well).
2. The visibility of the space which you want to be detected should not be jammed with objects as the
infrared beams cannot go through solid objects.
3. The halogen floodlight projector has to be protected against rain, heavy wind and direct sunlight.
4. The detection range should be small. The bigger the range the higher the probability of incorrect
Switching. You can limit the detection range by using non-transparent material (adhesive tape, for
Example). The detection range should be at a 90° angle with the movement direction of objects
(See pictures L and M). When an object hits the detection range, a maximum of beams will be touched.
o.k.
Picture L:
6m
Movement detector
Range at an indination of:
15°
15°
Inclination angle of 15°
seen from the side
2,5m
0 1 2 3 4 5 6 7 8 9 101112m
0 1 2 3 4 5 6 7 8 9 101112m
6m
5
4
3 Inclination angle of
2
15° seen from the top
1
0
1
110°
2
3
4
5
6m
A.
Picture M: not o.k.
6m
Movement detector
60°
60°
Inclination angle of 60°
seen from the side
2,5m
0 1 2 3 4 5 6 7 8 9 101112m
0 1 2 3 4 5 6 7 8 9 101112m
6m
5
4
3 Inclination angle of 60°
2
seen from the top
1
0
1
110°
2
3
4
5
6m
B. C.
1.
2.
Installation
1. Eliminate any voltage and check whether there
is really no voltage left
2. Pull the cable through the sealing opening.
Check carefully whether the sealing opening is
correct so that the device will be splash proof.
3. Installation according to picture attached.
4. Check carefully whether the pull relief works
Properly and use the pull relief in an appropriate
manner.
5. Fix the cap horizontally and screw it together so
that the device will be splash proof.
green/yellow
blue
How to use the halogen floodlight
projector
Installation of the bulb
1. Make sure that the projector is not connected to
the power supply
2. Remove the upper screw from the projector's
casing and remove the front glass.
3. Take the bulb out of its packaging. Do not touch
the bulb with your bare hand. Use a towel to fix
the bulb into the fitting. First press one side of the
fitting against the metal pin and shift the pin
Backwards so that you can press the other side of
the bulb against the metal pin.
4. After changing the light bulb, please pay attention
to the correct positioning of the seal.
5. Fix the front glass with the screw.
black/brown
L
N