Kickback And Related Warnings - Rebel RB-1030 Manual Del Usuario

Kickback and related warnings

Kickback is a sudden reaction to a pinched or snagged moving blade. Pinching or snagging
causes rapid stalling of the cutting accessory which in turn causes the uncontrolled power
tool to be forced in the direction opposite of the accessory's rotation at the point of the
binding. For example, if a blade is snagged or pinched by the work piece, the edge of the
blade that is entering into the pinch point can dig into the surface of the material causing
the blade to climb out or kick out.
The blade may either jump towards or away from the operator, depending on direction of
the blade's movement at the point of pinching.
Kickback is the result of power tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below:
• Maintain a firm grip on the power tool and position your body and arms to allow you
to resist kickback forces. Always use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during start-up. The operator can control
torque reactions or kickback forces, if proper precautions are taken.
• Never place your hand near the moving accessory. The accessory may kickback
over your hand.
• Do not position your body in the area where the power tool will move if kickback
occurs. Kickback will propel the power tool in the direction opposite to the blade's
movement at the point of snagging.
• Use special care when working corners, sharp edges, etc. Avoid bouncing and
snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag
the rotating accessory and cause loss of control or kickback.
Safety rules for laser guide
WARNING! Risk of serious injury!
• Staring directly at the laser beam may permanently damage your sight.
• Do not stare directly at the laser beam or aim it at people or animals.
• Do not aim the laser beam at reflective surfaces.
• Switch off tthe laser guide if the jigsaw is not used or during transport.
• Do not modify the jigsaw in order to increase laser power.
LASER RADIATION! DO NOT STARE DIRECTLY AT THE
LASER BEAM! CLASS 2 LASER PRODUCT
Wavelength (λ) = 650 nm; PO <1 mW
According to EN 60825-1:2014 standard
Products marked with this warning label are class 2 laser products in the wavelength range
of 635 to 670 nm according to DIN EN 60825-1:2014 standard. Do not stare directly at the
laser beam emitted from such products.
39 EN