Sebson IR WAL B Instrucciones De Manejo página 8

This SEBSON motion detector has an IR sensor that detects the heat radiation of moving objects and activates e.g.
a connected light.
Scope of delivery:

1 motion detector
General safety information:
Danger:
The installation of this product may be done only by a qualified person according the valid regulations for
electrical installation!
Danger:
In case of damages or contact with water turn off this product immediately without tension and make sure
that a restart is no longer possible!
Danger of suffocation:
parts that can be swallowed!
Caution:
Avoid overloading the device, an overload can damage the device or cause a short circuit! Therefore,
please note the maximum power consumption in the technical data!

The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer
be guaranteed if it is modified! In addition, this will invalidate the warranty claim!

The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!

Any other use than the description may result in damage to the product. So the dangers are such as
electric shock, short circuit, fire etc.

We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.

This product is only suited for indoor-use and not for outdoor-use!

Protect the product from external damage, heavy dirt, moisture and excessive heat!

In order that the warranty claim does not expire please use only the supplied items. Repairs may only be
done by an expert and only by using original spare parts!

In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Instruction for installation (Fig 5):
Danger:
Before installing please make sure that the circuit is interrupted! For installation, the work on the mains
voltage is required. Please remove the associated mains fuse or deactivate the switch fuse! Check by using a
voltage tester if the line is de-energized. Make sure that the current circuit will not closed during the installation!
Danger:
The installation of this product may be done only by a qualified person according the valid regulations for
electrical installation!
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!

Please observe the safety instructions and technical data before installing this product!

Note on installation:
L: Live wire (black or brown)
N: Neutral conductor (blue or grey)

This device is only suitable for wall mounting!

For optimum range, select the mounting height recommended in the "Technical Data".
Please keep this product away from children and animals. The packaging contains small
8