2. Fit the auxiliary handle into position and align the holes.
Fix by the bolt and the handle knob. Tighten the handle
knob to secure (Fig. 4).
Fig. 4
Handle knob
Fitting the Safety Guard
m
WARNING!
The safety guard must be properly installed.
The safety guard provides partial protection from the risk of
thrown objects to the operator and other bystanders.
1. Use a screw driver to remove the 4 safety guard screws
that pre-assembled on the motor housing (Fig. 5).
Retain the screws.
Fig. 5
2. Place the safety guard over the motor housing as shown.
Align the holes. Fix with the original 4 safety guard screws.
Tighten to secure (Fig. 6).
Bolt
Auxiliary handle
Safety guard screws
Motor housing
10
Fig. 6
Installing the Storage Compartment
1. To store your grass blades easily, just simply snap the
storage compartment onto the pole of the trimmer and
edger. Be sure that the storage compartment is right side
up to prevent blades from falling out (Fig. 7).
Fig. 7
Storage
compartment
2. The trimmer plate (or SharperBlade
can be snapped directly onto the compartment for safe
storage, when not in use. (Fig. 8-9).
Fig. 8
Trimmer
plate
Safety guard
screws
Safety guard
Motor
housing
Pole
mini trimmer blade)
™
Storage
compartment
Pole