sunjoe 24V-SB10-LTE Manual Del Usuario página 14

Edging
m
WARNING!
Because this procedure is close to the
On/Off switch, make sure to remove the battery before
converting the machine.
1. To convert your SharperBlade
slide the Twist-N-Groom
twist the handle clockwise to an angle of 180° while
holding the pole. Release the collar and ensure it snaps
into place (Fig. 21).
Fig. 21
Twist 180°
2
clockwise
Twist-N-Groom
™
locking collar
2. Loosen the handle knob and adjust the auxiliary handle by
pivoting it to a comfortable position. Tighten the handle
knob to secure (Fig. 22).
Fig. 22
Handle knob
Auxiliary handle
3. Use the edge of the guard as a guide when cutting near
fences and walls (Fig. 23).
trimmer into an edger,
™
locking collar downward and
™
Slide downward
Fig. 23
m
WARNING!
Do not trim near electrical wires.
4. To convert your edger back to a trimmer, hold the handle,
slide the Twist-N-Groom
twist the handle counterclockwise to an angle of 180°
while holding the pole. Release the collar and ensure
it snaps into place (Fig. 24). Adjust the auxiliary handle
as needed.
Fig. 24
Twist 180°
2
counterclockwise
Slide downward
Maintenance
m
WARNING!
Before performing any maintenance task,
turn off the machine and remove the battery.
m
WARNING!
Always wear protective gloves during
maintenance tasks. Do not carry out maintenance when the
engine is running or hot.
• Regular cleaning and maintenance of you grass trimmer +
edger will ensure efficiency and prolong the life of
your machine.
• After each cutting operation, take apart and clean out the
grass and soil from the whole trimmer + edger and guard.
• During operation, keep the air vents clean and free
from grass.
14
locking collar downward and
™
Twist-N-Groom
locking collar
™