Hilti SBT 4­22 Manual De Instrucciones Original página 12

Torque range (15 settings)
Torque (soft joint)
Ambient temperature for operation
Storage temperature
4.2 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Accessory tools – permissible diameters
Keyless chuck clamping range
Ø drill bit (softwood)
Ø drill bit (hardwood)
Ø drill bit (metal)
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 6
8 English
SBT 4-22
1.5 Nm ... 10 Nm
(1.1 ftlb
f
≤ 36 Nm
(≤ 27 ftlb
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
21.6 V
See the end of these
operating instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
SBT 4-22
1.5 mm ... 13 mm
(0.06 in ... 0.5 in)
1.5 mm ... 25 mm
(0.06 in ... 1.0 in)
1.5 mm ... 14 mm
(0.06 in ... 0.6 in)
1.5 mm ... 10 mm
(0.06 in ... 0.4 in)
2306836
*2306836*
... 7 ftlb )
f
)
f