Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.2
Selecting the gear
The gear selector switch can be operated only when the motor is not running.
▶ Select the gear.
6.3
Setting the torque
▶ Set the desired torque.
The torque is limited only when the power tool is set to screwdriving mode .
6.4
Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (switch-on
interlock).
▶ Set the forward/reverse switch to the desired direction of rotation.
6.5
Drilling
1. Set the function selector ring to the "drilling" position
2. Set the forward/reverse switch to the "forward" position.
6.6
Screwdriving
1. Set the function selector ring to the "screwdriving" position .
2. Set the torque setting ring to the desired torque.
3. Set the forward/reverse switch to the desired direction of rotation.
6.7
Switching off
▶ Release the control switch.
▶ The product switches off.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
10
English
3
4
5
.
2306836
*2306836*
Publicidad
Tabla de contenido
