Black and Decker D3310 Manual De Uso Y Cuidado página 4

AD DI TIO N A L F EATURE S
Burst of Steam
Use for ironing in the vertical and horizontal position. Press the
Burst of Steam button to generate a burst of steam. For best
performance, leave several seconds between bursts.
Spray Mist
Press the Spray mist trigger to generate a spray of water. Spray
Mist is used to dampen tough wrinkles while dry or steam ironing.
Do not spray silk.
3-way Auto Shut Off
The iron will automatically shut off after 30 seconds of inactivity
if left on its soleplate or side. If left vertically on the heel rest, it
will shut off after 8 minutes. When the iron is in Auto-Shut Off,
the red light under the handle will blink. Simply move the iron to
take it off stand-by.
6
I RONI NG TI PS AND TRI CKS
• The iron can be filled with ordinary tap water; if your
water is hard, you may want to use 50 percent distilled
water and 50 percent tap water.
• For optimum performance, allow the iron to stand on the
heel rest about two minutes after filling before beginning
to iron.
• If you're unsure of the fabric's content, test a small area
(on the inside seam or hem) before you proceed to iron
the entire garment or cloth.
• Whenever ironing a garment with mixed fabrics, select
the fabric setting for the most delicate fabric. For
example, when ironing a shirt that is 65% cotton and 35%
polyester, use the "blend" setting.
• Whenever temperature settings are changed to a higher
or lower temperature, allow the iron to stand 1–2 minutes
to allow heat up or cool down. Test garment by pressing
a small hidden area to make sure temperature of iron is
correct.
CLEANING AND C ARE
This product contains no user serviceable parts. Refer to service
qualified service personnel.
CLEANING OUTSIDE SURFACES
1. Make sure the iron is unplugged and has completely
cooled.
2. Wipe the soleplate and outer surface with soft, damp
cloth. Water and small amounts of gentle household
soaps, such as dishwashing liquid, can be used. Never
use heavy-duty cleaners, vinegar or abrasive scouring
pads that may scratch or discolor the iron.
3. After the iron has been thoroughly dried, turn the iron
back on and lightly steam over an old cloth. This will help
remove any reside left in the vents.
4. When finished cleaning, turn iron off and allow time to
cool before storing.
AUTO CLEAN™ SYSTEM
For optimal results over time, it is recommended that you clean
your iron about once a month to keep the steam vents free of
build up.
1. Fill the water tank well below the MAX fill line. Plug in the
iron.
2. Select the cotton/linen setting on the Temperature dial
and stand the iron on its heel while it preheats.
3. Once the iron has reached the desired temperature; turn
it off and then unplug it from the outlet.
4. Hold iron over a sink with the soleplate facing down.
5. Press and hold the AUTO CLEAN™ button . Be
careful, as hot water
and steam will come
out of the vents.
6. Continue to press the
button until all of the
water has emptied. If
necessary, move the
iron side-to-side and
front-to-back to aid
the process.
7. When finished, release the AUTO CLEAN™ button and
place the iron on its heel rest.
8. Plug the iron back in and allow it to heat for about 2
minutes to dry out any remaining water.
STORING YOUR IRON
1. Once the iron is turned off and unplugged from the
outlet, allow it
to cool.
2. Check that the variable steam dial is set to dry.
3. Wrap the cord loosely around the iron.
4. Store vertically on its heel to prevent water leaking from
the soleplate.
7