Publicidad
•IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE!
•THE USER MANUAL CONTAINS IMPORTANT INFORMATION ON THE CORRECT USE AND MAINTENANCE OF THE PRODUCT.
•WARNING! THE SHEMES AND FIGURES IN THIS INSTRUCTIONS ARE FOR ILLUSTRATIVE PURPOSE ONLY. THE PRODUCT
YOU HAVE BOUGHT MAY DIFFER FROM THEM.
I. WARNING AND RECOMMENDATIONS FOR SAFE USE
1.Warning! To be used under the direct supervision of an adult.
2.This ride-on car is suitable for children above 3 years of age and with weight up to 23 kg. The product cannot support
extra weight!
3.The toy is intended for use only by one child per session.
4.Warning! During assembly children should not be present. Choking hazard! Small parts.
5.Adult assembly required.
6.Warning! Risk from suffocation! Remove the package before you give the toy to the child. Children should not be
present during the unpacking of the toy.
7.The product is with music functions, which are activated via batteries. The batteries must be handled by an adult only.
8.Not to be used in traffic.
9.Not to be used on steep slopes or near stairs, near swimming pools or other water bodies. Use the product only on even
grounds and safe areas.
10.Do not allow another child to push the ride-on car while your child uses it.
11.Check regularly the condition of each part. In case of damage there is a risk of injuring your child.
12.Check regularly whether the nut and bolt on the steering wheel are fixed tightly and do not represent any danger.
13.If the product is not assembled properly this may lead to danger.
14.Do not allow the child to use the ride – on car barefoot.
15.Do not allow the child to remove the stickers, if there are any glued to the product, and to swallow them.
16.The raw materials and colors, used for producing the products, are suitable and safe for the children's health.
17.The toy complies with Standard EN71 and meets the essential requirements for "General safety of the product".
III. HANDLING OF THE BATTERY
1.The batteries should be handled by an adult only. The batteries are not toys. Do not allow the children to play with the
batteries.
2.Always use the same type of batteries. Do not mix alkaline batteries with standard (Carbon - Zinc) ones, or with
rechargeable (Nickel – Cadmium) ones.
3.The exhausted batteries must be removed immediately from the toy. If you will not use the toy for a long time, remove
the batteries from it before storing it.
4.When changing the batteries, always replace all the batteries. Never mix old batteries with new ones. Children should
not be present during the changing of the batteries.
5.Do not throw the exhausted batteries away with the household waste. They contain components that may hard the
environment. These components are recyclable. Dispose of such waste only at designated recycling sites/ landfills.
6.Do not throw the batteries in fire. Risk of explosion or leak.
7.Do not modify the electric circuit and do not add any other parts to it.
8.Do not shorten the battery terminals.
9.Do not charge batteries, which are not rechargeable.
10.If you use rechargeable batteries, first take out the batteries from the product and then charge them. The charging
should be supervised by an adult only.
11.Use batteries with the same size as marked on the battery compartment or as written in the manual.
12.Alkaline batteries are recommended.
III. PRODUCT PARTS
1.B – car body – 1 pc; 2.G – safety board – 1 set; 3.FR – foot rest – 1 pc; 4.SW –steering wheel – 1 pc; 5.SB – backrest – 1
pc; 6.PB – parent control handle– 1 pc; 7.AP – package with parts assisting the assembly – 1 pc; 8.WC – wheel covers – 4
pcs; 9.GC – connection of the safety board – 1 pc; 10.SC – steering column – 1 pc.
IV. ASSEMBLY STEPS
Read the instructions carefully before you start the assembly of the product. Follow the individual steps for assembly
strictly and check after each action, if you have fixed the individual parts tightly.
The front wheels may be pre-assembled to the car body.
1.Step 1 – See Figures 1A and 1B: Place the footrest in the bottom of the car body. Its plastic pins must enter the
openings in the car body. Push forward. Fix it using 4 screws and screwdriver.
2.Step 2 – See Figure 2: Place a washer on the steering column and slide the column through the opening in the bottom
front part of the car body.
3.Step 3 – See Figure 3A, 3B and 3C: Attach the steering wheel to the safety board connection. Then connect the plug of
steering wheel cables to the plug of the car cables. Insert the cables into the opening in the car body.
7
Publicidad
