Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLE
1. Place Stand A on Stand B to form X-base.
2. Place lower pipe with pipe support on X-base with four
screws provided.
3. Loosen and remove the pipe connector from lower pipe.
Slide plastic base ornament over lower pipe onto the base.
Extend upper (inner) pipe and slide pipe connector over
upper pipe into lower pipe and tighten.
4. Attach the motor with switch housing onto the upper pipe.
Ensure the switch housing is pushed fully onto the upper pipe
and secured with the screw provided.
EN
5. Loosen guard mounting nut from the motor housing.
6. Position rear guard firmly to motor housing and then
fasten by turning guard mounting nut clockwise tightly.
7. Remove and discard the PVC sleeve on the motor shaft.
8. Push the blade along motor shaft and fasten it firmly with
spinner by turning counter clockwise.
9. Hang the front guard to rear guard with the position fixer
provided at the rim of guard and then fix together with
screws and clips provided.
39
Publicidad
