Troubleshooting - Steren WR-202 Manual De Instrucciones

Problem
No sound; receiver RF light and mic not lit
No sound but the RF lights are glowing
Received signal is noisy or contains
interference with transmitter on
Momentary loss of sound as transmitter is
moved around performing area
Input:
AC power adapter
Input:
Output:
Product design and specifi cations are subject to change without Product design and specifi cations are subject to change without
previous notice previous notice

TROUBLESHOOTING

Make sure POWER switches in transmitters and receiver are set to ON
Check microphone battery to ensure they are providing power
Make sure antennas are in the microphones' line of sight
If necessary, reduce the disance between the microphones and receiver
Check the proper connection between receiver and exernal amplifier / mixer
Check microphone batteries or replace if power is low
Remove local sources of RM interference, such as lighting equipment.
Reposition receiver and perform a "walkthrough" test and observe the signal
strengths. If audio droppouts persist, mark these "dead spots" in the
performing areas and avoid them during the performance.
SPECIFICATIONS
12-15V
9V (microphone)
120V~ 60Hz
12V 300mA
ENGLISH-15
Solution
positions
Replace the battery if necessary
Check receiver's AC power connection
Turn up the receiver's volume level controls
Use squelch control to reduce the interference
300 mA (receiver)
7Wmax