Greenlee CMAF-1000 Manual De Instrucciones página 2

Description
The Greenlee CMAF-1000 and CMAF-3000 Flexible Clamp-on Adapters are AC-current
measuring accessories intended to be connected to any typical multimeter (purchased
separately) with the following characteristics:
• Has voltage and common (negative) terminals with 3/4" centerline spacing
• Capable of measuring AC millivolts
When connected to a true RMS meter, either model can obtain true RMS measurements.
Both models contain an electronic unit and a flexible sensor that is 12.5 mm (0.5") in diameter
and 610 mm (24") in length. The flexible sensor enables measurements on conductors where
standard clamp-on probes can not be used. In particular, it can be installed in tight places,
around breaker panels and around wide or large bus bars. The sensor can be shaped before
inserting it between or around conductors. In addition, this feature facilitates closing,
enhances user safety and alleviates the drooping effect typically associated with flexible
sensors.
The CMAF-1000 and CMAF-3000 units take a current input and produce a voltage output.
The CMAF-1000 produces 1 mV output for every amp of input. The CMAF-3000 is selectable
between 1 mV or 10 mV of output for every amp of input.
Safety
Safety is essential in the use and maintenance of Greenlee tools and equipment. This
instruction manual and any markings on the tool provide information for avoiding hazards and
unsafe practices related to the use of this tool. Observe all of the safety information provided.
Purpose
This instruction manual is intended to familiarize all personnel with the safe operation and
maintenance procedures for the Greenlee CMAF-1000 and CMAF-3000 Flexible Clamp-on
Adapters.
Keep this manual available to all personnel.
Replacement manuals are available upon request at no charge.
and are registered trademarks of Greenlee Textron.
KEEP THIS MANUAL
2