Temperature Adjustment; Cooling On/Off - Kenmore 596.7238 Manual De Uso Y Cuidado

Save/Confirm Temperature Settings
When you have finished adjusting both the refrigerator and
freezer set points, press MEASURED FILL to confirm and to
save the settings.
NOTE: To exit Temperature mode without saving changes, press
the ICE/WATER button under Back at any time, or allow about
60 seconds of inactivity. The temperature mode will turn off
automatically and return to the normal screen.
When adjusting temperature set points,
use the following chart as a guide:
CONDITION:
REFRIGERATOR too cold
REFRIGERATOR too warm
FREEZER too cold
FREEZER too warm /
Too little ice

Cooling On/Off

Your refrigerator and freezer will not cool when cooling is
turned off.
To turn cooling off, press and hold the LOCK and
MEASURED FILL buttons at the same time for 3 seconds. The
Cooling Off icon will blink seven times and then remain lit as
shown.
IMPORTANT:
To avoid unintentionally locking the dispenser or
changing other settings, press both buttons at exactly the
same time.
When cooling is off, the dispenser paddles and all
controls except Lock and Measured Fill are disabled.
A. Press LOCK and MEASURED FILL at the same time.
Press and hold LOCK and MEASURED FILL for 3 seconds
again to turn cooling back on.
Settings
Press the SETTINGS button to open the Settings menu and select
between Acceler-Ice, Filter Status or Vacation modes.
20
TEMPERATURE
ADJUSTMENT:
REFRIGERATOR Setting
1° higher
REFRIGERATOR Setting
1° lower
FREEZER Setting 1° higher
FREEZER Setting 1° lower
Press the ICE/WATER button at any time to return to the Normal
screen.
Acceler-Ice
The Acceler-Ice feature assists with temporary periods of heavy
ice use by increasing ice production.
To turn on the Acceler-Ice feature, press the SETTINGS
button to access the Settings menu, then press TEMP, under
Acceler­Ice to activate the feature. When the feature is on,
the Acceler-Ice icon will appear on the dispenser display
screen. The Acceler-Ice feature will remain on for 24 hours
unless manually turned off.
To manually turn off the Acceler-Ice feature, press the
SETTINGS button to enter Settings mode (unless you are
already in Settings mode), then press TEMP, under
Acceler­Ice, again. When the feature has been turned off,
the Acceler-Ice icon will disappear from the dispenser
display.
Filter Status
Displays the percentage of use remaining in the water filter
(from 100% remaining to 0% remaining).
To access Filter Status, press the SETTINGS button to access the
Settings menu, then press SETTINGS, under Filter Status, to
display the percent of life remaining in the water filter.
ALSO
The water filter status lights will let you know when to change
your water filter.
ORDER FILTER (Yellow) - Order a replacement water filter.
REPLACE FILTER (Red) - Replace the water filter. Replacing
the disposable water filter will automatically reset the water
filter status tracking feature. See "Water Filtration System."
NOTE: REPLACE FILTER will remain illuminated if a filter is
not installed or installed incorrectly.