F- Things That Must Be Done Before Calling Authorized Service; Troubleshooting - Ugur USS 100 SC Manual Del Usuario

F- THINGS THAT MUST BE DONE BEFORE CALLING AUTHORIZED
SERVICE

Troubleshooting

The failures and solutions stated in this section can be performed easily by yourselves and always consult to an Autho-
rized Uğur Service if these suggestions do not solve your problem.
CAUTION!
• Intervention to any failure that may occur in your product must be carried out by Authorized Uğur Service.
• Any intervention that may be done by you may harm you, your employee or customer, invalidate the product
guarantee and cause material damage (fire etc..).
• In case of any failure, consult to Uğur Customer Care or Authorized Uğur Service. (see Page 20)
Troubleshooting
Cooler is not working. (No sound
or only fan sound comes from the
product.)
Device internal temperature is high.
EN
Device internal temperature is very
low.
High degree of sweating on the
glass and inside the device.
Bad smell coming from the bottom
part of the cooler.
Ürünlerinizde kullanılan lamba veya ledlerin güç değerleri lambaların takılı olduğu bölümde olup
üründen ürüne değişiklik göstermektedir. Ürünlerinizde kullanılan lamba veya ledlere sadece Uğur
Yetkili Servisleri müdahale edebilir.
Possible Solution
It may be due to the thermostat
Not plugged in. The fuse may be
blown or broken down.
Condenser lamella may be ob-
structed or get dirty.
External ambient temperature is
very high or wrong thermostat
setting.
Very close to the back wall, ventila-
tion shutters are obstructed or it's
front is prevented.
It may have been expose to exces-
sive external wind.
Condenser lamellas are very dirty.
Wrong internal thermostat setting.
Water discharge hole may be
obstructed when sweating is seen
inside the cabin.
In glass sweating on the other hand,
current external ambient humidity
is over 65%.
Lower water discharge tray is dirty.
50
Result.
It will run again when reached to
the suitable temperature.
Insert the plug properly.
Consult to an Authorized Uğur Ser-
vice or a competent electrician.
Clean the condenser lamellas.
Move the cooler to a place where
the external temperature is lower.
Adjust to the stated gap.
Clean in front of the ventilation
shutters.
Prevent the wind.
Clean the condenser lamellas.
Re-set the thermostat.
Clean water discharge hole. With re-
gards to the high humidity, you can
move your cooler to an environment
with less humidity.
Su tahliye tavasını temizleyiniz.