Manual Setting Of All Route Points - Navitel E500 Manual Para El Usuario

64 | USER MANUAL - QUICK START GUIDE

Manual Setting of All Route Points

To plot a route where both the starting and the destination points are determined manually, first mark a point on the map in a
place where you plan to begin your route, and then tap "Cursor" [1] to proceed to the "My route" screen. Tap the information panel
at the bottom of the screen [2]. Select "Set start" in the "Properties" screen [3]. The program will request that you switch the GPS-
receiver off. The point will be marked on the map as a starting point. Select a destination point on the map: tap on the map to mark
the point, select "Cursor" [4], and then in the "My route" screen, tap "Go!" [5]. The program will plan a route [6].
EN
Fig. 1
Fig. 4
Fig. 2
Fig. 5
Fig. 3
Fig. 6