Tabla De Contenido; Safety Information; Warranty; Pre-Installation - ETI Solid State Lighting EM-ELC-R Guía De Uso Y Cuidado

Table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Hardware Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

safety information

WarninG: Carefully read and understand the information given in
this manual before beginning the assembly and installation. Failure to
do so could lead to electric shock, fire, or other injuries which could be
hazardous or even fatal.
WarninG: Ensure the electricity to the wires you are working on is
shut off. Either remove the fuse or turn off the circuit breaker.
WarninG: Risk of fire or electric shock. This product must be installed
in accordance with the applicable installation code by a person familiar
with the construction and operation of the light fixture's/luminaire's
electrical system and the hazard involved. If not qualified, do not attempt
installation. Contact a qualified electrician.
CaUTion: Disconnect power and unplug the battery before servicing.
Installation and servicing should be performed by qualified personnel.
Use only Manufacturer supplied replacement parts.
CaUTion: Battery inside product may not be fully charged. After
installed and power is turned on, the battery must charge for a minimum
of 24 hours before initial testing.
noTiCe: Equipment should be mounted in locations and at heights where it will
not be subject to tampering by unauthorized personnel.
noTiCe: Do not use this sign for other than its intended use. Do not use outdoors.
Do not mount near gas or electric heaters.

Warranty

This product is warranted for a period of 5 years from the date of original purchase against defects in materials and workmanship. If this
product should fail to operate due to defects in material or workmanship within 60 months of purchase, see www.ETiSSL.com for details.
This product will be repaired or replaced, at ETi's option. This warranty is expressly limited to repair or replacement of product, and liability
for direct, incidental, or consequential damages is hereby expressly excluded. Some states do not allow exclusions of direct, incidental or
consequential damages, so the above limitation of exclusion may not apply to you. This warranty gives the consumer specific legal rights,
which vary from state to state. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR THE PURPOSE WHICH THIS PRODUCT IS MANUFACTURED.
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Canopy Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Surface Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Testing the Battery Back-Up . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Adjusting the Light Heads . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
noTiCe: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and the
receiver.
□ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for
help.
WarninG: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
2

Pre-installation

PLANNING INSTALLATION

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with the package
contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
noTe: Keep your receipt and these instructions for proof of purchase.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.

TOOLS REqUIREd

Wire Safety
Strippers Goggles
Flathead Phillips
Screwdriver Screwdriver

PACKAGE CONTENTS

Part description quantity
A Exit Sign Housing 1
B Exit Sign Faceplate 2

HARdWARE INCLUdEd

noTe: Hardware not shown to actual size.
Part description quantity
AA Mounting Bracket 1
BB Mounting Canopy 1
CC Wire Connector 3
DD Electrical Box Screw 2
Ladder
Power Drill
with drill bits
A
B
AA
CC DD
3 WWW.ETiSSL.COM
Please contact 1-855-384-7754 for further assistance.
Gloves
Wire
Cutters
BB