Throttle Cable Installation, Adjustment
•
Link the throttle cable (G) to the speed control
lever (C) and loosely clamp the throttle cable outer
housing (F) with the cable clamp bolt (A).
Move the throttle lever to "FAST" position.
Pull up the outer housing (F) of the throttle cable
until the inner wire (G) has almost no slack, and
tighten the cable clamp bolt (A).
Move the throttle lever to "SLOW" position. Make
sure that the carburetor throttle valve (H) is moved
smoothly.
ADJUSTMENT
Choke Cable Installation, Adjustment
•
Link the choke cable (K) to the choke control lever
(D), and loosely clamp the choke cable outer
housing (L) with the cable clamp bolt (B).
Move the equipment choke control to "OPEN" po-
sition. Make sure that the carburetor choke valve
(I) is fully opened.
Pull up the outer housing (L) of the choke cable
until the inner wire (K) has almost no slack, and
tighten the cable clamp bolt (B).
Move the equipment choke control to "CHOKE"
position. Make sure that the carburetor choke
valve (I) is completely closed.
Make sure that the choke valve turns from fully
closed position to fully opened position when ac-
tuating the equipment choke control.
23
ADJUSTMENT