Desiccant For Preventing Humidity - Sanyo VCC-XZ600 Manual De Instalación

Desiccant for preventing humidity

Desiccant (blue: normal) has been placed inside the camera to prevent humidity. If the
desiccant has changed to a reddish-purple color, replace the desiccant with new desiccant
before installing the camera cover. If the camera is used without replacing the desiccant,
condensation may occur inside the camera and cause the lens to become foggy.
■ Replacing the desiccant
Be sure to observe the following,
otherwise the camera may become
damaged.
• Be sure to turn off the power.
• Do not allow the camera to get wet
from rain water or other liquids.
1
Loosen the four cover fixing screws.
Refer to step 1 in "Checking the menus
and zoom position using simple monitor
output". (P5)
2
Use the accessory hexagonal wrench
(small) to loosen the camera fixing
screw (A), and then remove the camera
unit (B) from the camera fixing bracket
(C).
(C)
3
4
(B)
5
(A)
6
Replace the desiccant with the
accessory desiccant.
Install the camera unit (B) as shown in
the illustration, and then align the
camera fixing screw (A) with the screw
hole (D) in the camera unit and tighten
them.
(C)
(A)
(D)
• Tighten the camera fixing screw so
that the screw head (E) do not
protrude by any more than 0.5 mm.
(F)
• When tightening the screws, the
camera fixing bracket (F) should be
horizontal.
Install the camera cover.
Refer to step 3 in "Checking the menus
and zoom position using simple monitor
output". (P5)
(B)
(E)