Metra 95-7360B Instrucciones De Instalación página 3

ISO DDIN radio provision
1. Break the small locating pin from
the inside surface of each bracket.
(Figure A)
2. Attach the radio to the brackets
with the screws supplied with
the radio. (Figure B)
3. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
4. Mount the new radio assembly into
the dash, snap the Metra radio trim
panel over the radio assembly, and
reassemble dash in reverse order
of disassembly.
Kit Assembly
Remove pin
(Figure A)
95-7360B
(Figure B)
3