Minimum Distances; Base Stand Assembly Instruction - Krüger & Matz KM0232-S5 Manual De Instrucciones

Caution
Do not place your television on an
unstable cart, stand, shelf or table.
Serious injury to an individual , and
damage to the television, may result if it
should fall.
INSTALLATION
• Locate the TV in the room where light does not strike the screen directly.
• TotaI darkness or a reflection on the picture screen can cause eyestrain. Soft and
indirect lighting is recommended for comfortable viewing.
• AIIow enough space between the TV and the wall to permit ventilation.
• Avoid excessively warm locations to prevent possible damage to the cabinet or
premature component failure.
• Do not cover the ventilation openings when using the TV.

Minimum distances

Base stand assembly instruction

When you install the base, the need to face down flat on the TV platform. Before
installing (or removing) the stand, unplug the AC power cord from the AC outlet
before performing the operation, laying cushion in place the TV will be placed to
prevent damage to the TV.
24
Owner's manual
Caution
When the television receiver is not used
for an extended period of time, it is
advisable to disconnect the AC power
cord from the AC outlet.
Owner's manual
A
B
Warning:
Be sure to follow the instructions for installation, if the base is not installed correctly,
it may result in the TV falling over. To remove the stand, perform the steps in reverse
order, the base can not adjust the angle. During the installation process, be careful
to avoid damage to the TV and your hand caught and ground to the bottom of the
TV.
Mounting on a wall
IMPORTANT This operation requires two people!
To ensure a safe installation, comply with the following safety instructions:
• Disconnect from power supply before mounting.
• Check that the wall can support the weight of the TV set and wall mount assembly.
• Follow the mounting instructions provided with the wall mount.
• The TV set must be installed on a vertical wall.
• Make sure to use only screws suitable for the material of the wall.
• Make sure that the TV set cables are placed in such a way that there is no danger
of tripping over them.
• Mounting the TV set on the wall should be performed only by professionals.
Step 1
Locate the 2 pcs of bottom
bracket into the gap in the
bottom of the TV, and check
that it is securely held in place
as in illustration A) below.
Step 2
Lock the 2 pcs screws in the
designated location as in
illustration B) below. Check
each screw is firmly tightened.
25