Cleaning - Steinbach Poolrunner Manual Original

Lifting the device out of the pool
Risk of electric shock if the control unit drops into the filled pool
while it is connected to the power supply.
- Pull the power plug out of the socket before lifting the device out
of the pool.
1. Slowly pull the device by the floating cable
can reach the handle
2. Slowly lift the device out of the water by the handle
surface for 10 to 15 seconds so that most of the water can flow back into the pool.
3. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued fault-free operation.

Cleaning

Improper cleaning might damage the device.
- Clean the surface of the device with plain tap water after each
use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
WARNING!
Risk of electric shock!
.
8
NOTICE!
towards the water surface until you
1
and hold it above the water
8
43