Storage; Troubleshooting - Steinbach Poolrunner Manual Original

8. Separate the top and the bottom part of
the filter unit.
9. Thoroughly rinse the bottom part and
the top part with the filter bag with
plain tap water.
10. Connect the top and the bottom part of
the filter unit and close all latches.
11. Rinse the device and the floating cable
after each use with plain tap water
inside and out.
The device is clean.

Storage

1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C)
without direct sunlight.

Troubleshooting

Fault description
The cable is twisted or tangled. The device turns in the water
19
20
Cause
during cleaning (this is
normal).
There are obstacles in the
pool.
The cable in the water is too
long.
Remedy
Switch off the device,
disconnect the cable and
untangle it.
Remove the obstacles.
Pull the excess cable length out
of the water. The cable in the
water should only be long
enough so that the device can
reach all spots in the pool.
45