Putting The Pool Cleaner Into The Pool - Maytronics Dolphin Explorer Classic 9 Instrucciones De Uso

Position the power supply so that it is approximately in the middle of the long side of the pool at a
distance of 3m/10ft.
Attach the floating cable to the power supply
by inserting it with the notch on the connector (1)
lined up with the groove in the socket on the
power supply and turning clockwise (2).
2
1
Plug in the power supply and leave it in the OFF position.

5.2. Putting the Pool Cleaner into the pool

If your Pool Cleaner is equipped with brushes that
contain sponges, dip the brushes in the water and
squeeze them so that they will absorb water the first
time you use the Pool Cleaner, or if the brushes have
dried out between uses.
Release the Pool Cleaner and let it sink to the floor
of the pool.
Make sure that the floating cable is free of any
obstructions.
To avoid kinks in the floating cable, place
approximately enough cable in the water for the
Pool Cleaner to reach the farthest corner of the
pool.
Dolphin Explorer Classic 9 / Top 9 User Instructions
|
5
8151620_Expolorer_all languages.indd 5 6/03/13 5:25 PM