Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] Sul lied
Accessories
owner's
manual
quick start guide
(1EMN24299)
(1EMN24639)
remote control
registration
card
Phillips pan screw for
(NH000UD)
(1EMN24700)
attaching
the stand x 4
(FPH34200)
batteries
(AAA x 2)
. If you need to replace these accessories, please refer to the part No. with the illustrations
and call our toll free
customer
support
line found on the cover of this manual.
[] Attaching
the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
!
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
_
Hang the hook under the bottom
of the main unit to the stand's hole
(shown arrow _), then slide down the
stand in the direction of the screen
(shown arrow @).
Make sure not to put the AC power
cord between
the stand and the
unit.
@
_
Drive Phillips pan screws in the 4
threaded
holes at the bottom
of the
stand with a screwdriver
tightly.
To remove
the stand from
this unit
Unscrew the Phillips pan screws indicated by "@'_ Pull up the
stand in the direction of the rear of the unit. Becareful not to drop
the stand when you remove it.
Note:
• When attaching
the stand, ensure that aft screws are tightly
fastened.
If the stand is not properly
attached,
it could cause the unit to fall,
resulting
in injuries as well as damage
to the unit.
• Make sure to use a table which can support
the weight
of this unit and is larger than this unit.
• Make sure the table is in a stable location.
[]Symbols
Used in this Manual
The following
is the description
for the symbols used in this manual. Description
refers to:
: Analog TV operation
: Digital TV operation
. If neither
symbol appears
under the function
heading, operation
is applicable
to both.
EN
Publicidad
Tabla de contenido
