Metra 95-7882B Instrucciones De Instalación página 3

Kit Preparation
1.
Secure the factory components removed in dash disassembly to the radio panel. Except for the
(3) screws to secure the lower trim panel, either the factory screws or the (9) #8 x 3/8" Phillips
pan-head screws supplied with the kit may be used. For the lower trim panel use the (3)
#4 x 3/8" Phillips truss-head screws supplied with the kit to secure it to the panel. (Figure A)
2. Attach the (3) metal and (3) plastic panel clips to the radio panel. The factory metal
clips may be used in place of the metal clips, but not the plastic clips. (Figure A)
Continue to kit assembly
Metal clip locations
Plastic clip
locations
(Figure A)
95-7882B
ISO DDIN radio provision
1. Secure the radio brackets to the radio
with the screws supplied with the
radio. (Figure A)
2. Secure the completed assembly to the
radio trim panel with the (4) #8 X 3/8"
Phillips truss-head screws supplied
with the kit. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Re-connect the negative
battery terminal and test the radio for
Plastic clip
proper operation .
location
4. Reassemble the dash in reverse order
of disassembly using the (2) #8 x 1/2"
Phillips pan-head screws supplied with
the kit for the lower radio mounts .
3
Kit Assembly
(Figure A)
(Figure B)