Grohe Ladylux Pro 31 040 Manual Del Usuario página 4

Application
Pot Fillers can be positioned above sinks, stoves or in
a counter top and the articulated nature of the spout
enables the outlet to be conveniently position above
pots / pans as required.
Specifications
• Min. flow rate
• Flow pressure
- min.
- recommended
- greater than 72.5 psi, fit pressure reducing valve
• Max. operating pressure
• Test pressure
Installation
Flush pipes thoroughly!
Mount pot filler
Refer to the dimensional drawing on fold-out page I.
1. Push on escutcheon (A), see fold-out page II, fig. [1].
2. Fit O-Ring (B).
3. Insert faucet into sink.
4. Push on fibre washer (C) and steel washer (D) from
below.
5. Screw on counter nut (E) and tighten with an 31mm
open-ended wrench.
Connect pot filler
For this purpose the supply hose must be connected to
the angle stop, see fig. [2].
Open water supply and check connections for
watertightness!
Operation
For ease of use the pot filler is fitted with two head-
parts.
If the pot filler is to be left unattended ensure both
headparts are left in the closed position.
1
15 L/min or 4 gpm / 20 psi
7.25 psi
14.5 - 72.5 psi
145 psi
232 psi
English
IMPORTANT:
NOT FOR USE AS A FIRE EXTINGUISHER!
Maintenance
Inspect and clean all parts, replace as necessary and
grease with special grease.
Shut off water supply!
I. Replacing the headparts, see fig. [3].
1. Pull off shut-off knob (F).
2. Loosen screw (G) and pull off snap insert (H).
3. Pull off sleeve (I).
4. Unscrew headpart (J) by using a 17mm socket
wrench and remove O-ring (K).
5. Change complete headpart (J) and reinstall
O-ring (K).
II. Hinged socket, see fig. [4].
1. Unscrew pot filler arm (L).
2. Unscrew hinged socket (M) by using an 10mm
allen wrench.
III. Mousseur, see fold-out page I.
Unscrew and clean mousseur (13 983).
Assemble in reverse order.
Observe the correct installation position!
Replacement parts, see fold-out page I ( * = special
accessories).
Care
Instructions for care of this faucet will be found in the
Limited Warranty supplement.