Cleaning & Maintenance; Cleaning: Dishwasher & Hand-Washing; Removing & Reinstalling The Silicone Ring; Cleaning The Lid - Ninja Foodi OL550EU Instrucciones

CLEANING & MAINTENANCE
Cleaning: Dishwasher & Hand-Washing
The unit should be cleaned thoroughly
after every use.
1 Unplug the unit from the wall socket
before cleaning.
2 To clean the cooker base and the
control panel, wipe them clean with
a damp cloth.
3 The cooking pot, silicone ring, reversible
rack, Cook & Crisp Basket and
detachable diffuser can be washed in
the dishwasher.
NOTE: NEVER put the cooker base in
the dishwasher or immerse it in water or
any other liquid.
4 The pressure release valve and anti-clog
cap, can be washed with water and dish
soap.
5 If food residue is stuck on the cooking
pot, reversible rack or Cook & Crisp
Basket, fill the pot with water and allow
to soak before cleaning. DO NOT use
scouring pads. If scrubbing is necessary,
use a non-abrasive cleanser or liquid dish
soap with a nylon pad or brush.
6 Air-dry all parts after each use.
73 ninjakitchen.eu
Removing & Reinstalling
the Silicone Ring
Silicone Ring
Silicone
Ring Rack
To remove the silicone ring, gently pull
it outward, section by section, from the
silicone ring rack. The ring can be installed
with either side facing up. To reinstall, press
it down into the rack section by section,
(see image above).
After use, remove any food debris from
the silicone ring and anti-clog cap.
Keep the silicone ring clean to avoid odour
Washing it in warm, soapy water or in the
dishwasher can remove odour. However,
it is normal for it to absorb the smell of
certain acidic foods. It is recommended
to have more than one silicone ring
on hand. You can purchase additional
silicone rings at ninjakitchen.eu.
NEVER pull out the silicone ring with
excessive force, as that may deform it and
the rack and affect the pressure-sealing
function. A silicone ring with cracks,
cuts or other damage should be
replaced immediately.
NOTE: The silicone ring must be replaced
by one that is specific to a Foodi®
SmartLid Multi-cooker.

CLEANING THE LID

We recommend inspecting the interior
of the lid and heating elements prior to
cooking with "wet cooking functions,"
which include Slow Cook, Steam, Sear/
Sauté, Pressure and all Combi-Steam
modes. If you see any food residue or oil
buildup, we recommend steam cleaning the
unit (see instructions below), then wiping
down the interior of the lid.
STEAM CLEANING INSTRUCTIONS:
1
Fill pot with 700ml of water.
2 Move SmartLid Slider to Air Fry/Cooker.
3 Select STEAM, and set time to
30 minutes. Press START/STOP.
4 When time reaches zero and the unit
has cooled down, use a wet cloth or
sponge to wipe down the interior of
the lid and heating elements. CAUTION:
When cleaning the interior of the lid, do
not touch the fan.
5 Repeat steps 3 and 4 as needed and
spot clean as necessary.
NOTE: If the unit is not open after
the cycle is over, the unit will default to
KEEP WARM and the heating element
will continue running.
ninjakitchen.eu 74