Wi-Fi Protected Setup - Cisco Linksys X Serie Manual De Instrucciones

Linksys X-Series
RADIUS
This option features WEP used in coordination with a RADIUS server . (This
should only be used when a RADIUS server is connected to the router .)
NOTE
If you select RADIUS as your Security Mode, each device in your
wireless network MUST use RADIUS and the same encryption and
shared key .
RADIUS Server
Enter the IP address of the RADIUS server .
RADIUS Port Enter the port number of the RADIUS server . The default is 1812 .
Shared Key
Enter the key shared between the router and the server .
Encryption Select a level of WEP encryption, (40/64-bit 10 hex digits) or
104/128-bit (26 hex digits) . The default is 40/64-bit (10 hex digits) .
Passphrase
Enter a passphrase to automatically generate the WEP key . Then
click Generate .
Key 1 If you did not enter a passphrase, enter the WEP key manually .
Disabled
If you choose to disable wireless security, you will be informed that wireless
security is disabled when you first attempt to access the Internet . You will given
the option to enable wireless security, or confirm that you understand the risks
but still wish to proceed without wireless security .
NOTE
When wireless security is disabled, anyone can access your wireless
network at any time .

Wi-Fi Protected Setup

Three methods of Wi-Fi Protected Setup are available . Use the method that
applies to the client device you are configuring .
Advanced Configuration
18