Publicidad
4-Flat & 6-Way Combination Harness
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the tow vehicles 4-flat trailer wiring connector. If the vehicle
is not equipped with a 4-flat trailer connecton, installation of a T-
Connector or other 4-flat trailer wiring product will be required prior to
continuing this installation.
3. Locate an appropriate mounting position on the tow vehicle for the
combination harness. The mounting bracket should be attached
directly to the tow vehicle's bumper or other stable surface, such as a
Hitch Attachment Bracket (Valley Part No. 32432). The connectors
must be mounted in an area within reach of the trailers wiring harness,
near the center of the tow vehicle. Mount the combinaton harness to
the vehicle utilizing the supplied mounting bracket.
4. Using the bracket as a template, drill two 7/64" holes into the
mounting surface. Secure the bracket to the vehicle using self tapping
screws (provided).
Caution: Do not drill into any exposed surfaces or through
the vehicle body.
Warning: Never attach the mounting bracket directly to the
hitch by cutting, welding or drilling into the hitch.
5. Attach the harness connectors to the mounting bracket.
6-Way Connector: Feed the entire harness through the large
opening of the mounting bracket
and position the connector against
the face of the mounting bracket.
Attach using the mounting screws
provided (Fig.1).
4-Flat Connectors: Slide the 4-
flat connector up into the mounting
hole until the locking tabs at the bottom
Fig. 1
Publicidad
