Lens & Helmet Maintenance - Smarter tools Mega-550S Manual Del Usuario

IX. LENS & HELMET MAINTENANCE
DO NOT! use corrosive solvent on the filter screen or any of the
•
helmets components
DO NOT!
•
If helmet is not in use, please keep it in a dry place. Be aware that the
•
Auto-darkening filter should not be placed in direct light to avoid
unnecessary filter adjustments. It may cause damage to control system.
Clean the filter lens with a clear lint-free tissue or cotton cloth
•
You should inspect this helmet frequently and immediately replace worn or
•
damaged parts.
Replace the Front Lens Cover if it is damaged (cracked, scratched, soiled or
pitted).
1. To Replace the Cover:
A. Lift up on the tab at the bottom of the outer frame to unsnap the
B. Remove the protection film from both sides of the new Lens if it
C. Place the new lens into place and snap the frame securely to hold
2. Clean the filter lens with a clean lint free tissue or cotton cloth.
3. Do not immerse the lens in water or any other liquid. Do not use
abrasives, solvents or oil based cleaners.
4. Do not remove the auto--darkening filter from the Auto Darkening
Welding Helmet. Do not try to open the filter.
5. Storage temperature -4° F to 158° F.
immerse the filter lens in water or any other liquid
frame and access the lens cover. Pull out the lens cover.
comes with a film covering.
the lens in place.
8