Axis M1045/65-LW Guia De Instalacion página 23

Ocultar thumbs Ver también para M1045/65-LW:
Tabla de contenido

Publicidad

English
Safety information
Read through this Installation Guide carefully before
installing the product. Keep the Installation Guide
for future reference.
Hazard levels
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NO TICE
NO
NO
TICE
TICE
Indicates a situation which, if not avoided, could
result in damage to property.
Other message levels
Important
Indicates significant information which is essential
for the product to function correctly.
Note
Indicates useful information which helps in getting
the most out of the product.
Safety instructions
WARNING
IR emitted from this product. Do not stare at
operating lamp.
NO TICE
TICE
NO
NO
TICE
The Axis product shall be used in compliance
with local laws and regulations.
The product shall be grounded either through a
shielded network cable (STP) or other appropriate
method.
Store the Axis product in a dry and ventilated
environment.
Avoid exposing the Axis product to shocks or
heavy pressure.
Do not install the product on unstable poles,
brackets, surfaces or walls.
Use only applicable tools when installing the Axis
product. Using excessive force with power tools
could cause damage to the product.
Do not use chemicals, caustic agents, or aerosol
cleaners.
Use a clean cloth dampened with pure water for
cleaning.
Use only accessories that comply with the
technical specification of the product. These can
be provided by Axis or a third party.
Use only spare parts provided by or recommended
by Axis.
Do not attempt to repair the product yourself.
Contact Axis support or your Axis reseller for
service matters.
The power supply shall be plugged in to a socket
outlet installed near the product and shall be
easily accessible.
Use a limited power source (LPS) with either a
rated output power limited to ≤100 W or a rated
output current limited to ≤5 A.
Transportation
NO
NO TICE
NO
TICE
TICE
When transporting the Axis product, use the
original packaging or equivalent to prevent
damage to the product.
Battery
Low battery power affects the operation of the RTC,
causing it to reset at every power-up. When the
battery needs replacing, a log message will appear
in the product's server report. For more information
about the server report, see the product´s setup pages
or contact Axis support.
The battery should not be replaced unless required,
but if the battery does need replacing, contact Axis
support at www.axis.com/techsup for assistance.
Lithium coin cell 3.0 V batteries contain
1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
WARNING
Risk of explosion if the battery is incorrectly
replaced.
Replace only with an identical battery or a
battery which is recommended by Axis.
Dispose of used batteries according to local
regulations or the battery manufacturer's
instructions.
Français
Informations sur la sécurité
Lisez attentivement ce guide d'installation avant
d'installer l'appareil. Conservez le guide d'installation
pour toute référence ultérieure.
Niveaux de risques
DANGER
Indique une situation dangereuse qui, si elle n'est pas
évitée, entraînera le décès ou des blessures graves.

Publicidad

Tabla de contenido
loading

Tabla de contenido